Basic Information: klippy.log Hello everyone, when I print the extruder, after few layers, doesn’t extrude anymore. Why? This is the klipper log: klippy.log (397.7 KB)

Depends on what you want to use. Important is, that in the slicer and in the slicer’s start code is set the same [grafik] [grafik]

Have you checked the extruder mode? Could it be that the printer is in absolute mode and the slicer is in relative mode?

Where I can check they and, in case, change they?

In the slicer. What slicer du you use? There is a setting for the slicing and one in the slicer’s start code for the printer (M82/M83) https://reprap.org/wiki/G-code#M82:_Set_extruder_to_absolute_mode https://reprap.org/wiki/G-code#M83:_Set_extruder_to_relative_mode

I use Cura. Which between M82 and M83 I have to use?

Extruder doesn't extrude

General Discussion

Sineos December 18, 2023, 12:54pm 3

Your log is showing Timer too close errors.

Topic		Replies	Views
Set position extruder General Discussion	6	550	January 19, 2024
Exclude object still tries to extrude but without moves General Discussion	6	144	October 4, 2024
Problem: Move exceeds maximum extrusion General Discussion	8	39985	September 7, 2023
Move exceeds maximum extrusion General Discussion	17	2730	July 23, 2024
Filament . one or two forward... one back General Discussion	2	164	January 3, 2024

Extruder doesn't extrude

Related topics