Basic Information: Printer Model: ender 3 s1 MCU / Printerboard: stock, f401 klippy.log Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Knowledge Base” Category first. Mo…

I put down in printer.cfg the include pis.cfg Instead of top of the file, it seems to work… And reflashed the pis and numpy on raspberry pi…

Where is the original Klippy.log? Please attach this and not any other formats or logs. Your attachment is the firmware if I’m not wrong. The FYSETC-link has the SPI-bus commented out. Did you check this as well? What happens if you change it to spi_bus: PIS:spi1a ? I have similar acceleromet…

Actually there are two issues: [adxl345] ... spi_bus: spi1a spi_software_sclk_pin: PIS:gpio10 spi_software_mosi_pin: PIS:gpio11 spi_software_miso_pin: PIS:gpio12 ... [resonance_tester] accel_chip: adxl345 usbadxl You are mixing hardware SPI and software SPI. The Fysetc works only with software …

I tried to comment in and out, nothing happen…

This is usb, why remove it? This is the original file from fysetc… But if you think it will help, I’ll try. I want to understand why?

If you want to access it via its custom name you have to declare the name before: [adxl345 usbadxl] And then you can access it with [resonance_tester] accel_chip: usbadxl Or keep the defaults like @Sineos suggested.

[image] i dont have red error in mainsain page, but i have this… [image]

What kind of cable are you using and how long is it? The description in the console already points you towards a solution.

You mean an USB-C to USB-A cable or what? Is it shielded or just cheap?

Fysetc portable input shaper adxl345: spi must be on same muc

General Discussion

matanel83 November 29, 2023, 1:49pm 7

Understand. I’ll check and reply if working or not.
Why their default file like this i don’t know…

Anycybic I3 Mega/orangepi zero 3/ adxl345/ i2c

Topic		Replies	Views
Fysetc Portable Input Shaper General Discussion	6	2202	February 27, 2024
FYSETC adxl345 - Invalid adxl345 id (got ff vs e5) General Discussion	8	1166	September 29, 2024
ADXL345 inputshaper not working General Discussion	5	863	September 24, 2023
Klipper auto-tune input shaper with ADXL345 settings problem General Discussion	11	2321	May 18, 2025
Anycybic I3 Mega/orangepi zero 3/ adxl345/ i2c General Discussion	11	2136	February 4, 2024

Fysetc portable input shaper adxl345: spi must be on same muc

Related topics