Help extruder_stepper_free

General Discussion
1

Basic Information:

Printer Model: flybear reborn 2
MCU / Printerboard: BTT E3EZ / EBB36
klippy (1).log (1.0 MB)

Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

… Internal error during connect: function/symbol ‘extruder_stepper_free’ not found in library ‘/home/biqu/klipper/klippy/chelper/c_helper.so’: /home/biqu/klipper/klippy/chelper/c_helper.so: undefined symbol: extruder_stepper_free
I built this 3d printer about a year ago worked great I put in storage for about 3 months due to a home remodel. I got it out today and updated the klipper software and I got this Error. I searched the forum only one other post with same problem but it has no resolve any help would be great.

2

Git version: 'v0.12.0-410-gcf3b0475' seems fine, so probably you just did not restart klipper after pull of git changes.

Just a software reboot of the system should be enough, chelper got recompiled on fresh Klipper start.

3

I have tried rebooting still no luck but I think the if she lies with the EBB 36