I need Klipper Cura help!

General Discussion
1

Basic Information:

Printer Model: Ender 3 Pro
MCU / Printerboard: Creality 4.2.7
Host / BTT Pi
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…i have 3 printers running on 1 pi all configured and working perfectly via mainsail i use cura slicer and can remotely send file from cura to printer1 but cannot figure out how to add the other 2 printers to cura when i add in cura with ip & port that does not work cura crashes

2

See Cura | Mainsail
If this does not work, the relevant Cura plugin likely does not cover this scenario correctly. You should address this issue at GitHub - emtrax-ltd/Cura2MoonrakerPlugin: Ultimaker Cura 2 Mooraker Upload Plugin

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.