Input shaper moves really slow all of a sudden

General Discussion
1

Basic Information:

Printer Model: Voron 2.4
MCU / Printerboard: Octopus Pro
Host / SBC BTT pi2
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…Hi I just went to go run input shaper and it moves REALLY slow and quite far from end to end. Any idea why this would be happening all of a sudden?

2

See resonance_tester: Added a new sweeping_vibrations resonance test method by dmbutyugin · Pull Request #6723 · Klipper3d/klipper · GitHub

3

Um thanks but I don’t understand any of that.

4

I just went with mainline Klipper on my SV08 and my input shaper also moves really slow and much more travel of the toolhead. Way different than what it was before. Wonder if that’s the new method they discussed? I really don’t know. It came up with values and saved them. Haven’t tried printing yet.