After enabling the servo, the servo turns and then loses mcu communication [image] Below is the configuration file printer.cfg [servo mg996r_servo] pin: PA8 # 信号引脚 minimum_pulse_width: 0.0005 # 500μs maximum_pulse_width: 0.0025 # 2500μs [gcode_macro SAFE_ENABLE] gcode: S…

[image] anons: Below is the configuration file printer.cfg This is not a complete printer.cfg. [image] anons: Get the following log 2. klipper.log This is not the complete klippy.log. Please attach at least the klippy.log complete (as a file) to your next post.

[image] Klipper enabled the steering gear, which caused the mcu to die General Discussion Below are the configuration and log files printer (3).cfg (5.1 KB) klippy (4).log (29.6 KB)

Klipper enabled the steering gear, which caused the mcu to die

General Discussion

anons March 30, 2025, 3:36pm 3

Below are the configuration and log files
printer (3).cfg (5.1 KB)
klippy (4).log (29.6 KB)

Topic		Replies	Views
Mcu timeout during servo move General Discussion	15	1190	July 10, 2022
Servo motor causing Lost communication with MCU 'mcu' General Discussion	7	353	January 5, 2025
MCU Communication problem - Klipper infinite STARTUP loading General Discussion	3	181	October 18, 2025
Can not update MCU 'mcu' config as it is shutdown General Discussion	0	1943	April 10, 2022
MCU 'mcu' shutdown General Discussion	3	204	June 12, 2024

Klipper enabled the steering gear, which caused the mcu to die

Related topics