Klipper error unknown pin chip can0

General Discussion
1

Basic Information:

Printer Model: Anycubic Chiron
MCU / Printerboard: BTT Manta m8p V1.1 / EBB36 V1.2
Host / SBC BTT CB1
klippy.log is to long

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

I have the BTT Manta m8p v1.1 and the BTT EBB36 and have flashed everything successfully, but I get the error unknown pin can0 in klipper, what could be the reason.
Both UUIDS can be seen via SSH, but I have problems starting the Canbus network and I can’t re-flash klipper Canbus

2

grafik
grafik1069×206 16.3 KB

can0 cannot appear anywhere in a pin definition, so your cfg is faulty.

Check the documentation how to properly setup a CAN connection.

1 Like
3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.