Klipper Fluidd estimation time is start time of print

Hi there, I have been noticing recently that my Estimated finish time is actually always displaying the start time of the print,
Like today, I have started my print at 09:59, which is not when it will finish approx 8 hours later… (6PM)

Does anyone have a similar issue? Do I need to change something in my slicer to achieve a proper finish estimation time?

Mine is the same. Just wish that it could be solved, but looking at the response it has generated I won’t be holding my breath.

That would explain why I could never figure out where that was coming from!

Check Slicer - Mainsail and make sure to have your slicer properly setup

I am using fluidd though :thinking:

Doesn’t matter

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.