Basic Information: Printer Model: RSE Core XY Printer MCU / Printerboard: MKS PI Host / SBC Klipper klippy.log Describe your issue: … Second time that printer is shutting down mid print. I already consulted configuration reference and adjusted the “verify heater” section within my configur…

Thanks mate. Very useful post. Totally agree ! Obviously the bed heater is somehow not heating at expected rate. I really don’t know why because I set 60C temperature and the bed heats perfectly fine up to 120C. Also wiring and installation is without flaw and usually looked and worked good. I h…

Unfortunately, the log you provided does not contain the event you are reporting. Without a log showing it, no further guidance can be provided.

Which log should I provide? Is it not the standard klippy.log where all information should be contained?

[image] remarkable_sir: Is it not the standard klippy.log where all information should be contained? Usually yes, but the log should include the occurrence of the issue. So, try again to heat. When the issue kicks in, send a M112 from the terminal and then attach the klippy.log to your next …

I‘m not able to set M112 command because the machine is shutdown and non responsive. I didn’t update the machine for a couple of month. On my update info box I see several issues and available updates. And also „corrupted „ on the Klipper button. Could a bad Setup somehow be responsible for this k…

It happened again :frowning_face: Would you mind check what the reason could be? New klippy.log attached. klippy.zip (1.7 MB)

More important is the line before: Transition to shutdown state: Heater heater_bed not heating at expected rate Something weird is going on with your bed: [grafik]

Oh shit, actual temp is heavy away from target… Is there also a timestamp? So I’m not sure if the drop occurred within minutes or maybe one hour…

There are timestamps but they are not immediately translatable to “human” time and in almost no case this is needed either. Such sharp drops as shown by @EddyMI3D typically point to a defect temperature probe. Either the probe itself or its wiring / connectors. Each stats line is 1 second and it i…

Klipper Shutdown Error 'verify_heater' - Help with Klippy.log

General Discussion

Sineos October 7, 2024, 4:11pm 2

See Heater <name> not heating at expected rate

Topic		Replies	Views
Klipper is shutting down while heating General Discussion	19	2136	November 23, 2022
Verify_heater issue General Discussion	6	205	December 27, 2025
Disable heater extruder verify General Discussion	9	1982	March 7, 2024
Printer keeps shuting down on certain part General Discussion	8	216	April 30, 2024
Klipper shuts down during extruder calibration General Discussion	3	446	February 12, 2024

Klipper Shutdown Error 'verify_heater' - Help with Klippy.log

Related topics