Basic Information:
Printer Model: Sovol SV06
MCU / Printerboard: Stock
Rasberry Pi 3B
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not n
eeded
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:…
logs-20241016-085337.zip (882.3 KB)
I started a new print last night for an overnight run and it stopped somewhere in the middle. The only thing showing was “MCU SHUTDOWN” and in the console log was:
11:36 AM FIRMWARE_RESTART - me restarting after I found it failed
7:02 AM Klipper state: Shutdown
2:34 AM B:60.5 /60.0 T0:221.1 /220.0
2:33 AM B:60.0 /60.0 T0:179.0 /179.0
(One thing I don’t understand is the time stamps - I did the firmware restart at like 6:30 - 7:00 am and I double checked that my Pi has the correct time and date on it)
Yesterday I had shut down the Pi and Printer at least twice and used KIAUH to confirm everything was up to date.
Any help or suggestions with this would be appreciated