Mesh not self adjusting

General Discussion
1

Basic Information:

Printer Model: Voron 2.4r2
MCU / Printerboard:Octopus
Host / SBC rpi 4b
klippy.log
klippy.log (2.4 MB)

Describe your issue:

…after performing a quad gantry level then a bed mesh. During printing the first layer, the z axis doesn’t seem to compensate enough for the uneven bed.
I can feel the z motors pulsing but I suppose they’re not moving enough?
Any advice would be greatly appreciated

IMG_0032
IMG_00321320×2868 257 KB

I may have got a setting wrong, I don’t know.

I’ve tried heat soaking bed for 20 mins with print head over the middle of the bed. I’ve checked the sensor offset and the belt tensions. Here are the probe accuracy readings

IMG_0036
IMG_00361320×2868 280 KB

2

The problem is now sorted as there where no one who could answer the question I tried adjusting the settings
In the slicer (the height and width )

3

And by what?

1 Like
4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.