Moonraker won't come up properly

[mykepredko]

Good to know - I’ll take it out of my imaging process.

Could you take a look at:

Continued Problems connecting Klipper Serially

Basic Information: Printer Model: N/A MCU / Printerboard: BTT SKR Mini E3 V3 Host / SBC: Raspberry Pi Zero 2W klippy.log (39.9 KB) The saga continues. So, I have the Mainsail webpage coming up, I am comfortable knowing that the Mini E3 is being programmed with Klipper (as noted elsewhere I am erasing the STM32’s Flash and turning on and off the STATUS LED). I have an oscilloscope hooked up to the RX and TX lines and I see NRZ serial data going back and forth at 250,000 bps. But I am st…

Thanx!