PB to connect to MCU after update

General Discussion
1

Basic Information:

Printer Model: Aquila X2
MCU / Printerboard: SKR mini E3 V3.0 with BTT PAD7
klippy.log
klippy (1).log (296.4 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Hello,
…After updating Klipper (v0.12.0-114) I have this message : "mcu’mcu’ Unable to connect. I have change USB cable, flashed the firmware 3 times.
biqu@BTT-Pad7:~$ ls /dev/serial/by-id/*
ls: cannot access ‘/dev/serial/by-id/*’: No such file or directory

2

Did you try https://klipper.discourse.group/t/how-to-trouble-shoot?

Good luck, hcet14

3

See Issues flashing the printer board

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.