Basic Information: Printer Model: DIY coreXY Printer MCU / Printerboard: RAMPS-FDv2 klippy.log Fill out above information and in all cases attach your klippy.log file. Pasting your printer.cfg is not needed Be sure to check our Knowledge Base and in particular this and this post Describe you…

Thank you. I have also configured my printer.cfg by reading this topic. So I was able to switch the extruder with T0 and T1, but I was having trouble tuning the pressure advance. The documentation also mentions the EXTRUDER argument. SET_PRESSURE_ADVANCE [EXTRUDER=<config_name>] [ADVANCE=<pressu…

[image] Unable to infer active extruder stepper General Discussion I have been running a 2 in one out Non-Mixing Extruder Config with SHARED_HEATER on the 2nd extruder successfully for a while. Apparently SHARED_HEATER is being deprecated and replaced with [extruder_stepp…

Pressure advance in multihead

General Discussion

Sineos March 25, 2023, 6:33am 2

Topic		Replies	Views
Why am I getting "! Unable to infer active extruder stepper" when trying a pressure advance tuning tower? General Discussion	4	595	September 29, 2023
Pressure advance in all stepper extruders Features	21	487	November 25, 2025
Unable to infer active extruder stepper General Discussion	5	2675	September 30, 2024
Switching between extruders General Discussion	22	19914	November 22, 2023
Geeetech A20T: Unable to infer active extruder stepper General Discussion	6	569	April 4, 2024

Pressure advance in multihead

Related topics