Problem with simultaneous connection of two printers

[EddyMI3D]

Hello @alfredcollie !

The Klipper is a firmware solution that splits into two parts:

1. The host on the SBC/PC that does the calculation work
2. And the client that runs on the printer’s mainboard and does the connection to the hardware

So both make one unit an can not be separated.
For your second printer you need a second Klipper host.

More information here:

Klipper Architecture / Ecosystem

Klipper Architecture / Ecosystem Calling Klipper a 3D printer firmware is not complete to its full extent. In fact it is a 3D printing application with an associated ecosystem. The following overview shows how the different aspects interact. Only the red boxes is Klipper in its original sense, the other boxes are independent products forming the entire ecosystem. [Untitled Diagram.drawio] Klipper Host The core of the Klipper environment Typically running on a Single Board Computer (SBC), …