Basic Information:
Printer Model: Voron 2.4R2
MCU / Printerboard: BTT Kraken
Host / SBC/ RPI
klippy (1).log (1.6 MB)
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
I’m using a Phaetus Rapdio 2f and wiring the PT1000 to the BTT Kraken MAX31865 onboard, but using a LDO Nitehawk SB toolhead board, on a Stealthburner, but Klipper is not allowing any SPI configuration for the max31865 in the extruder section. It did when I was using a BTT SB 2040 toolhead board with an onboard max31865. The LDO Nitehawk SB toolhead board doesn’t have a max31865
…