Basic Information: Printer Model:Sovol SV08 MCU / Printerboard: Host / SBC klippy.log Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Knowledge Base” Category first. Mo…

Hi @honk013 , Which heater and thermistor are you using? A link would be helpful here. Does heater have its own internal temperature PID control, or does it rely on external control? If it relies on external control, you can configure it as a heater_generic with a heater and thermistor pin and let…

Hello, it is a small 60 x 60 mm PTC Heater. BUT it is not about the Heater or the Sensor!! They are working fine, in my configuration. It is about the Shelly Relay controlling this Heater (On / Off). I want to know if it is possible to receive the information about the Status of this Relay from Kl…

I just supplemented the power entry in the moonraker.conf by the “poll_interval” point. [power Enclosure_Heating] type: shelly address: 192.168.XXX.XXX poll_interval: 5 Now Klipper is also noticing the power change of the Relay when I do it via the Shelly WebUI i.e.

Kind request: Please use the Preformatted Text feature of the forum editor when posting code. It’s way better readable then and leading spaces are not omitted. [Format]

It may be possible to “Get” the status from a macro if you don’t want to “poll” continuously. docs/external_api/devices.md master # Switches, Sensors, and Devices This document covers the API for managing various devices through Moonraker. It should be noted that the endpoints…

Hello everyone, I learned in the last weeks, that the status information (state) of a power device configured in the moonraker.conf is NOT available in Klipper (to use it in a macro)! You can switch this device with macros in the printer.cfg of Klipper on or off, but you can not get the state of t…

Status Information of Power Device?

General Discussion

Sineos September 4, 2025, 3:20pm 3

Check if the following answers your question: Configuration - Moonraker

Topic		Replies	Views
Checking power state of Home Assistant device General Discussion	1	374	July 21, 2025
Klipper macro for reading energy meter "Shelly Pro 1PM General Discussion	2	198	September 7, 2025
Problems switching on the printer with moonraker General Discussion	3	239	March 11, 2025
Toggle main cabinet LED with Klipperscreen display KlipperScreen	8	469	December 11, 2025
Moonraker does not report printer state General Discussion	3	328	April 9, 2024

Status Information of Power Device?

Related topics