Basic Information: Printer Model: Ender 3 MCU / Printerboard: Creality 4.2.2 I bought a Trianglelab CHC CR-10 Hotend that i have installed on my machine, apparently it has an integrated thermystor (ATC Semitec 104NT-4-R025H42G). my printer.cfg has the sensor specified as: sensor_type: ATC Semi…

[image] engsdt: i read somewhare that Klipper´s default ADC voltage is 5 Where? Best is to stick to the official Klipper reference: https://www.klipper3d.org/Config_Reference.html#common-thermistors There for a thermistor the ADC voltage is not relevant. BTW: Most printer boards run on 3.…

Hi here you have the solution [image] Unable to set temperature sensor ATC Semitec 104NT-4-R025H42G General Discussion Hi there te correct solution is: from this source: Thermistors for Klipper | LDO Documentation and datasheet: https://atcsemitec.co.uk/wp-content/uploa…

Thermystor ATC Semitec 104NT-4-R025H42G and Creality 4.2.2 Board

General Discussion

klich3 December 5, 2023, 7:43pm 3

Hi here you have the solution

Regards

Topic		Replies	Views
Unable to set temperature sensor ATC Semitec 104NT-4-R025H42G General Discussion	6	13729	April 24, 2024
Incorrect heater bed readings using adc_temperature section General Discussion	9	1757	July 22, 2023
Thermistor measurement confusion General Discussion	7	2227	October 30, 2023
Configuring themristor from old printer General Discussion	21	266	November 26, 2024
Changed to a PT1000 and now ADCout of range General Discussion	23	906	August 13, 2025

Thermystor ATC Semitec 104NT-4-R025H42G and Creality 4.2.2 Board

Related topics