ill watch it thanks ill post how it goes
its in german
sorry that was nonsense.
The attempt to help is surely appreciable but seems to be lacking any structure. From my perspective, it is not clear:
- Exactly which hardware we are talking about
- The goal of how this should be connected
- Which additional hardware (e.g., Eddy) is involved
- Finally, a
klippy.log
@ten57: May I propose:
- List exactly all your hardware components—full and exact name including revision
- Draw a rough sketch of how you connected them or intend to do so. You may look at this link for an idea
- Provide a
klippy.log - Reduce to the minimum, e.g., only the Kraken board.
- Concentrate on this board. What is flashed and how? How is it connected?
btt pi 2 connected to btt kraken by usb kraken is then connected to btt ebb36 by can btt eddy connected to ebb36
i flashed using katapult as per the esoterical guide said im stuck here its like it keeps dropping usb and flash klipper
klippy (10).log (1.1 MB)
Flash board (Katapult + Klipper) according to BigTreeTech Kraken | Esoterical’s CANBus Guide and then follow the USB-CAN-Bridge Mainboard
This setup does not return anything by ls /dev/serial/by-id/* unless the board is in Katapult mode. The printer.cfg needs to contain the CAN UUID as described in the guide.
i think i got it now thanks for the help now i have to get the eddy going
i did it! yes
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.