Using Klipper with Raspberry Pi camera

General Discussion
1

Basic Information:

Printer Model: BLV CUBE
MCU / Printerboard: Octopus pro
Host / SBC pi4
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

The camera can be found using the rpicam but I don’t know how to add the camera into Klipper. I had a previous Klipper/pi version on a 2nd pi4 I swapped the SD card and the camera works fine and comes up in klipper.

I just can’t get the camera working with the latest version of Klipper and Linux

Hence reaching out here and on the raspberry pi forum. I know it’s just a simple config setup. Thanks all

Thanks all

…

2

Did you include crowsnest in your new install?

Please upload a klippy.log and a crowsnest.log

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.