Connecting octopi to ad5m running klipper firmware

General Discussion
1

Basic Information:

Printer Model: AD5M
MCU / Printerboard:
Host / SBC RasPi 4b
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Im not able to make a serial connection between octopi and my AD5m running klipper firmware. Octopi isnt able to find the connection. I have it plugged into the usb port on ad5m screen

2

Hello @Alund1990 !

How did yo get the system onto the Pi’s SD card?

Did you use the image that is provided with the Raspberry Pi Imager or did you use KIAUH?

3

I used the image from the raspberry imager

4

Then you should use /tmp/printer to connect OctoPrint to Klipper.

To connect Klipper to the printer, you have to follow this:

https://www.klipper3d.org/Installation.html#building-and-flashing-the-micro-controller