Basic Information: Printer Model: MCU / Printerboard: Host / SBC klippy.log Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Knowledge Base” Category first. Most relevan…

Hi, I have finaly resolved the problem. Motors assignation was… wrong ! X and X2 were affected at the back X1 and X3 at front… Thank you for your help and your fast answers :slight_smile:

You want to read here: [image] Understanding X and Y Axes Limits and Homing Knowledge Base The X and Y Axis Klipper needs to know from its printer.cfg settings how far the X and Y axes can safely move without hitting the printer’s frame. It also needs to know…

I have already but this doesn t explain how to set up correctly the origin. Only thing i could have done is to reverse the dir_pin. it worked but messed up the quad gantry level macro. Also it’s not explained how to make a homing toward max_pos or min_pos :confused: I think it’s probable obvious b…

You have to properly declare your steppers and where the endstops are located: [stepper] - Configuration reference - Klipper documentation This document is a reference for options available in the Klipper config file. For non standard definitions you can pl…

[voron 2.4 homing] how to define origin where I want?

General Discussion

LifeOfBrian May 14, 2026, 1:28pm 2

You want to read here:

Topic		Replies	Views
Help setting origin & X/Y axis limits General Discussion	7	2929	February 10, 2024
Understanding X and Y Axes Limits and Homing Knowledge Base	0	19823	October 2, 2023
Understanding X and Y limits and homing....Questions General Discussion	25	2830	March 16, 2024
Voron SW Wrong direction of Y General Discussion	3	1071	December 23, 2023
X axis moves when Y moves General Discussion	11	1122	March 1, 2024

[voron 2.4 homing] how to define origin where I want?

Related topics