Basic Information:
Printer Model: Ender 3 v2
MCU / Printerboard: BTT manta M4p
klippy.log klippy.log (223.7 KB)
Describe your issue: I have a fresh install on the ender 3 v2 running a manta m4p with the CB1. My issue is that i cannot seem to get my x-endstop to work. My y-endstop works and my z endstop is a bltouch which i haven’t tested yet. As far as i know, i have wired everything correctly (wires going to signal and ground) and i have set the correct pin on the “endstop_pin:” (i have set the x endstop pin to “!^PC0”). I have uploaded my klipper log file. i’m not sure how to interpret it because i am new to klipper. any help woulld be greatly appreciated.
Hello @Manu4619 !
Have you checked the switch for functionality?
I have. I replaced the x endstop with the endstop that was for the y axis and it still doesn’t work.