Xin hãy giúp tôi sửa lỗi máy in Neptune4 pro

General Discussion
1

Basic Information:

Printer Model:
MCU / Printerbmcu mcu : Unable to connect.O
nce the underlying issue is corr
ected, use the. FIRMWARE_RES
TART command to reset the fir
mware, reload the.config, and r
estart the host software…Error
configuring printeroard:
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
mcu mcu : Unable to connect.O
nce the underlying issue is corr
ected, use the. FIRMWARE_RES
TART command to reset the fir
mware, reload the.config, and r
estart the host software…Error
configuring printer

Describe your issue:

…

2

The Neptune 4 Pro uses a modified version of Klipper.

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.