Basic Information:
Printer Model: creality cr10s pro v2
MCU / Printerboard: atmega 2560
fluidd
klippy.log - >
klippy.log (6.5 MB)
Describe your issue:
Hi,
I’ve been using my klipper consistantly for a while now but after my last print, I have an issue with my zoffset. I made the “paper test” multiple times with the mesh of the bed. The issue is that, either my first layer look nice but the second layer is awfully close to the bed and is squishing (worst than just ironning) the layer underneath or I purpusefully make my first layer way too far from the bed and get my second and third layer almost ok. (still looks a bit ironned)
What is happenning ? Can you enlight me ?
[EDIT]
ok, just found the solution… ahh ! It was my z axis bar who was tilte ! Probably making the head not reaching the proper z height because of that. I used two old 3d printed tower on each side, turn the axis rod to decrease the side who was too high in order to have it all leveled. Then releveled my bed. (it was completely wrong lol). and after a couple of tweat it works great now. Hope it will stays the same.