Basic Information: Printer Model: Anycubic Kobra Go MCU / Printerboard: Trigorilla klippy.log Attached klippy.zip (1.3 MB) Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check ou…

[printer] kinematics = cartesian max_velocity = 45 max_accel = 1000 You are missing proper velocity and acceleration settings for Z in your config. Add something like: max_z_velocity: 5 max_z_accel: 100 to this section. As I do not know the printer you might have to find the limits, but in any ca…

Z using X Y Velocity / Accel & X Y using Z Speed after Homing

General Discussion

burners January 6, 2024, 8:20pm 4

Stepper noise
Klipper-Issue.zip (2.0 MB)

SET_VELOCITY_LIMIT for Z-axis on Cartesian

Topic		Replies	Views
Homing vs automatic Z-offset General Discussion	1	71	September 8, 2024
Z-axis default lifting speed problem General Discussion	0	248	January 17, 2023
Start print homing after tall print - is this a bug? General Discussion	6	480	April 15, 2024
Z-Probe Homing Behaviour General Discussion	1	117	May 29, 2024
Kobra MAX/CatBoat - Move out of range while homing z General Discussion	7	336	February 24, 2024

Z using X Y Velocity / Accel & X Y using Z Speed after Homing

Related topics