Anycubic Kobra Go does not work extruder and heater bed

General Discussion
1

Basic Information:

Printer Model: anycubic kobra go
MCU / Printerboard: Raspberry Pi 3 Model B Rev 1.2 / Huada Semiconductor HC32F460
klippy.log
klippy.log (454.3 KB)

Hello, please help. The printer stopped heating the bed and extruder. When installing the factory firmware everything works, but when installed the klipper stops working. The mosfet on the board opens when commanded, but no voltage is supplied to the table and extruder.

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…

2

Replace

[output_pin enable_pin]
pin: PB6

with

[output_pin enable_pin]
pin: PB6
value: 1
1 Like
3

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.