Basic Information:
Printer Model: Kobra 2
MCU / Printerboard: TriGorilla Pro B V_1.0.2
Host / SBC Rpi 3b+
klippy.log
klippy (6).log (2.9 MB)
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
I used to use a feature that was recently removed in the newest klipper update. It was
pin: PB4
static_value: 1
I needed this to heat the bed of my printer. But now that it is gone i am unable to heat the bed. Whats the fix?
edit: Nothing heats. If i just remove the section it guides me to the [verify_heater] section but i have no idea how to use this