Artillery X1 printing issues

General Discussion
1

Basic Information:

Printer Model:
MCU / Printerboard:
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Having issue with Artillery X1 printing inconsistencies. Calibrated flow rate, pressure advance but print looks very ugly. I dried the filament just in case. Any help will be appreciated.

image
image482×536 60.5 KB

klippy (1).log (311.2 KB)

2

Have you tuned in your printer and slicer correctly?

Here is a good guide:

3

This is a duplicate of that thread that was in the wrong category:

4

I closed that one.

1 Like
5

Either:

  • Massively over extruded
  • Skipping steps of the extruder
  • Clogged nozzle
  • Severely mistuned pressure_advance

Always hard to tell from such pictures.

6

The printer yes, I do have to look at my slicer. The printer did ok with Marlin before upgrading. I will work on slicer this weekend.
Thanks

7

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.