Bed Mesh bug

Basic Information:

Printer Model: Voron 2.4R2
MCU / Printerboard: M8P+EBB2209 Can
Host / SBC BTT CB1
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

For a few days now, I’ve been having a problem where my prints don’t match the Z-height. The layer height is uneven on the Y axis after the bed mesh.

Without the bed mesh, the error disappears. I had no problems before updating to 0.13.0 and didn’t change any configuration.

Current version v0.13.0-51-gbfda326c
klippy.log (6.5 MB)

Hi @Robin3D ,

Please upload your klippy.log. We need it to fully help you!

Ok, i uploaded it in the origin post.

Please: New information always to new posts.

1 Like

Ok sorry.
klippy.log (6.5 MB)

2 Likes

reinstall klipper and flashing boards NO solution

Downgrade to the last commit of 0.12.0 helps. I think the problem come from any commit from 18.April. I let it on 0.12.0 and never update Klipper again.