Bed mesh shows on z tilt or without z tilt difference (z) height

[Marcokitt2000]

Basic Information:

Printer Model:
MCU / Printerboard:
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Please check the 2 photo’’s one bed mesh with tilt and no tilt but difference you see same bedmesh but 1 is above the 0 and the other down 0. on sovol sv07 old armbian and all so with bookwurm with klipperscreen not the sovol. Is this a reset issue in tilt when do bed mesh i think it wil print same. this is mks klipad50 for sovol use.

…

[EddyMI3D]

Hello @Marcokitt2000 !

Please attach the klippy.log as it was requested.

[Marcokitt2000]

klippy(1).log (4.2 MB)

Sorry i have this added but i think its going wrong here.

On youtube there is a guy lau… has on sv07 some video and he say that to difference bed mesh i think 1 time without z-tilt.