Basic Information: Geeetech A20 M8p+CB1 klippy.log Hi all Phil here, noob with Klipper i have purchased a BTTManta M8P to replace the failing stock board. i have had “fun” working out how to install and configure Klipper, and working my way through all the challenges that that threw up. So…

[stepper_z1] step_pin = !PD3 dir_pin = PD2 enable_pin = PD5 endstop_pin = probe:z_virtual_endstop microsteps = 16 rotation_distance = 8 Change the enable pin to !PD5.

Hi jakep_82 thanks for that, have made the change, still no extruder!!??

klippy (9).log (1.2 MB) sending again

@jakep_82 asked you to change this line: [stepper_z1] ... enable_pin = PD5 to [stepper_z1] ... enable_pin = !PD5 If the extruder does not work, try this: [extruder] ... enable_pin = PD1 to [extruder] ... enable_pin = !PD1 BTW @jakep_82 : Please use code braces when you post code: [Format]

@PhilG What version is your M8P? The stepper pins for M6 - M8 are different between the two versions. [IMG_8092] [IMG_8093]

Is the cable plugged into the 4th or 5th connection on the Manta board? it has the 3rd and 4th running in parallel.

Hi guys I run 2 z axis motors. 1 to4 look after motion and using 5 for the extruder.

@NAPCAL … my saviour. Now have extruder in motor8 configured to v1.1. Still getting driver errors. The 2209 is now in standalone mode I can extrude molten plastic:+1::grinning::innocent: The next hurdle is getting my head around macros. Configuration and calibration. Thanx everyone for the advi…

BTT Manta M8P Extruder

General Discussion

Topic		Replies	Views
Manta m8p v2 extruder not working General Discussion	1	228	April 23, 2024
Extruder pin used as a Stepper pin General Discussion	5	130	October 14, 2024
Help with extruder in klipper General Discussion	17	251	November 12, 2025
Issue with extruder wont move General Discussion	10	247	July 3, 2025
My extruder and z1 does not work General Discussion	3	191	March 14, 2024

BTT Manta M8P Extruder

Related topics