Basic Information: Printer Model: custom MCU / Printerboard:BTT KRAKEN+BTT CB1 Host / SBC klippy.log Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Knowledge Base” Cat…

I followed it exactly. I have read people have not been able to get it to work because it will shut off before the system boots. Thanks for the reply.

Maybe I’m a bit slow today: Does it mean it is working correctly for you?

No, the relay would shut down before the system booted.

I have no first-hand experience with this relay, but it seems that the firmware on the relay has some room for improvement. See Firmware source code · Issue #4 · bigtreetech/BIGTREETECH-Relay-V1.2 · GitHub for a discussion and alternative firmwares.

BTT Relay shutting down

General Discussion

Sineos August 31, 2024, 5:56am 2

See the discussion here: BTT Relay V1.2 with SKR Mini E3 V3.0 - shuts down before Klipper loads - #2 by Sineos

Topic		Replies	Views
BTT Relay V1.2 with SKR Mini E3 V3.0 - shuts down before Klipper loads General Discussion	10	4372	April 3, 2024
Btt Relay 1.2 klipper config General Discussion	8	2073	April 2, 2024
CR10 Smart with SKR mini e3 v3 and sonic pad General Discussion	2	228	June 21, 2025
Shutting down during prints General Discussion	7	2827	December 25, 2022
PI disconnected mid print out of nowhere and now the entire host ''died'' and is unresposive General Discussion	10	227	July 13, 2024

BTT Relay shutting down

Related topics