Basic Information:
Ender 3
MCU / SKR mini E3 V1.2
Host / Debian 12 LAPtop
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
cant home z-axis.
When homing “all” from Mainsail x,y works fine, Z lifts a small amount goes to enstop, back to middle of build plate, drops bltouch sensor needle and stops
when looking in console it states : BLTouch failed to verify sensor state
I have tested according to config doc and it works (BLTOUCH_DEBUG COMMAND=touch_mode etc.)
I am totally new to klipper and trying to go from Marlin to Klipper.
don’t know how to troubleshout this so any suggestion are highly appreciated
/FF.
