Cant start print after today update

General Discussion
1

Basic Information:

Printer Model: Vcore 31
MCU / Printerboard:Octopus Pro
Host / SBC Rpi4
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Hi,

I updated the firmware this morning, and problems…

I tell as a memory what happened:

  • I have updated the klipper with FLuidd to version v0.12.0-171-g2f6e94c9
  • I have rebooted
  • After restarting I tried to print.
  • Almost at the end of making the Bed Mesh, with a Beacon. It gave me an error and restarted.
  • From that moment on, when it restarts and I put it to warm up or do homing on the axes, it restarts, given an error. This:
10:27:33 
// Klipper state: Disconnect
10:27:33 
!! Unhandled exception during run
10:27:33 
// Unhandled exception during run
// Once the underlying issue is corrected, use the
// "FIRMWARE_RESTART" command to reset the firmware, reload the
// config, and restart the host software.
// Printer is shutdown
10:27:33 
!! Unhandled exception during run
10:27:33 
// Unhandled exception during run
// Once the underlying issue i
[klippy.log|attachment](upload://zSOhNqExdP1CdNcMmDTBdqpOCRY.log) (2.3 MB)

…

3

I thought I added it

klippy.log (2.3 MB)

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.