Basic Information: Printer Model: geeetech i3 MCU / Printerboard: gt2560 Host / SBC surface 4 w linuxmint klippy.log Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Kno…

Well I got it working with another board the mks base v1.3 its still an atmega2560 chip and UART0 worked like a charm, I used the generic_ramps.cfg config, all steppers and endstop seem to work! Ill just have some tweaking to do in the printer config because of my franken setup.

Yeah i read that yesterday i get the same .elf.hex file for flashing, but it seems like everyone are flashing their boards with a .bin file.

[mcu] serial: /dev/ttyUSB0 Copied and pasted from the gt2560 basic config. It seems like I should use this interface but when I’m in the “make menuconfig” I only have the UART0 - 1 - 2 etc options to choose from

Communication interface

General Discussion

theophile February 25, 2025, 7:06pm 2

Maybe try here: Geeetech a10t and klipper - #4 by Swets

Topic		Replies	Views
Geeetech a10 klipper install help General Discussion	6	165	July 13, 2025
Config for GTM32_103_V1? General Discussion	14	2334	May 5, 2024
MCU unable to connect on mks v1.4 General Discussion	3	94	December 5, 2025
BIGTREETECH-GTR V1.0 menu config General Discussion	10	8184	December 24, 2021
MKS Gen_L V2.1 firmware General Discussion	7	504	January 18, 2025

Communication interface

Related topics