Communication timeout during

[EddyMI3D]

Please have a look on these:

Timeout with MCU / Lost communication with MCU

Timeout with MCU / Lost Communication with MCU Background This error occurs when the Klipper host receives no response from a connected MCU to its regular “heartbeat” or other command messages for several seconds. It often appears in conjunction with the Got EOF when reading from device error. Important: Klipper only detects the symptom - a communication loss. It is not capable of determining the root cause, which may lie outside of Klipper’s control (e.g., hardware faults, power i…

Mcu: Serial connection closed / Timeout on connect / Wait for identify_response

mcu: Serial connection closed / Timeout on connect / Wait for identify_response Background The printer-board / MCU did not respond to the connection attempt of the Klipper Host until finally the serial connection timed out and was closed. Often, these 3 errors will go hand in hand in the klippy.log Reasons Hardware issues between the board and the SBC, e.g. USB port, USB cable etc Wrong parameters during make menuconfig when building the firmware for the board Firmware not correctly flashed to…