Communications interface

Basic Information:

Printer Model: Voron 2.4 rc2 350
MCU / Printerboard: Octopus 1.1
Host / SBC orange pi zero 2
klippy.log no klippy.log file yet

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…I am in the make menuconfig and am confused about the proper settings for direct canbus communication using the canbus port on the octopus bd.
which settings are the proper ones?

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.