Config file help

Trimixdiver1 · September 14, 2023, 11:39am

Basic Information:

Printer Model: v2.4 r2 350
MCU / Printerboard: Octopus
klippy.logn/a

I just bought a used fombot 2.4 r2 350 with CAN from the octopus CAN port to an EBB36, it also has TAP. I had to install a new image and the seller didn’t have a backup of klipper. Can someone help me out with a config that can get me started? Thanks

theophile · September 15, 2023, 1:55pm

github.com

sttts/voron-klipper-config/blob/master/printer.cfg

## Voron Design VORON2 250/300/350mm SKR 1.4 TMC2209 UART config

## *** THINGS TO CHANGE/CHECK: ***
## MCU paths							[mcu] section
## Thermistor types						[extruder] and [heater_bed] sections - See 'sensor types' list at end of file
## Z Endstop Switch location			[homing_override] section
## Z Endstop Switch  offset for Z0		[stepper_z] section
## Probe points							[quad_gantry_level] section
## Min & Max gantry corner postions		[quad_gantry_level] section
## PID tune								[extruder] and [heater_bed] sections
## Fine tune E steps					[extruder] section

##========================== Pin Definitions ========================
## X_STEP_PIN         2.2
## X_DIR_PIN          2.6
## X_ENABLE_PIN       2.1
## X_STOP_PIN         1.29
## E0_DET_PIN         1.26
## X_UART_PIN         1.10

This file has been truncated. show original

system · November 14, 2023, 1:56pm

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.

Topic		Replies	Views
M8p cb1 klipper config General Discussion	6	735	July 30, 2024
Klipper cant communicate with mcu General Discussion	23	9149	May 26, 2024
Communications interface General Discussion	1	22	September 20, 2024
No /tmp/klipper_host_mcu file General Discussion	1	1147	January 25, 2023
Voron 2.4: Can not update MCU 'mcu' config as it is shutdown General Discussion	17	2311	May 4, 2024

Config file help

Basic Information:

Related topics