Voron 2.4 klipper connection to printer

General Discussion
1

Basic Information:

Printer Model: Voron 2.4
MCU / Printerboard: octopus
Host / SBC: BTTPI SB2209 with U2C SB2209/2240
klippy voron April 2024.log (33.2 KB)
CAN board
klippy.log

Describe your issue:

Hi still very new to Klipper as i have failed to get it going on 2 different computers but want to make this work on the Voron. I have spent a lot of hours looking for the answer to this problem. this appears to be the last problem to getting my Voron up and running finger crossed. I have not been able to connect printer to Moonraker and Klipper
“Option ‘position_max’ in section ‘stepper_z’ must be specified”
Thank you

2

Change [stepper_z0] to [stepper_z] and [tmc2209 stepper_z0] to [tmc2209 stepper_z] in your printer.cfg

1 Like
3

Thank you much appreciated will have to try tomorrow