Corners of cube not printing

General Discussion
1

Basic Information:

Printer Model: Creality K1
MCU / Printerboard:
Host / SBC
klippy.log
klippy.log (5.9 MB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…
Hello everybody.

I am 3d printing for two years and went from creality print to orca slicer. But never dared to root my printer. How ever someone convinced me to do so and told me to start using klipper. I installed it a couple of weeks ago (https://guilouz.github.io/) and loved all te options I now had.

I did a big bunch of prints using petg last week and everything was great. Then I got a message on my K1 that there was a update for the firmware and if I rooted the printer I needed to go back to factory settings. So I did and updated the printer after the factory reset and after that I installed Klipper (and all the other parts) again. But there is something wrong. The printer no longer prints corners. See the test cube pics. I’ve searched the internet but cannot find someone with the same problem. If I print the same cube with Creality Print it comes out perfect.

I don’t know where to find this, so if this is needed, could someone tell me how to find this information?

MCU / Printerboard:
Host / SBC

I just want to get back to printing flawless with Klipper. Can someone help me?

Thanks in advance.

2

This printer uses a modified Klipper version - rooted or not rooted, does not matter. In addition, there are some license concerns.

Such printers are not supported here. Please either revert to some Creality forum or contact them directly.

3

Sorry. I did not know this. I tried to remove my post, but I’m not allowed to do so.

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.