Cr6-se OrcaSlicer Post-calibration print issue, under extrustion? (benchy smoke stack / haul)

[3dthesenuts]

Basic Information:

Printer Model: cr6-se
MCU / Printerboard:stm32f103xe/
Host / SBC:RPi4
klippy.log
klippy.log (7.5 MB)

I have done all the calibration steps for orca slicers and all klipper calibration checks but i am still experiencing issues with my print quality. it seems to be a coin toss and my benchy is worse than before the conversion to klipper so i’m nearly certain it isn’t cooling. I have a Direct Drive mod on and have calibrated my retraction as well.

…

[3dcoded]

@3dthesenuts

i’m nearly certain it isn’t cooling

The benchy looks like it has cooling issues, particularly on the bow and smokestack.

Are you sure you’re not printing faster with Klipper than you were with Marlin?

[3dthesenuts]

I will do some more extensive cooling/print temps and report back

[Sineos]

Cooling issue, layer time too small and potentially too hot and over-extruded.