Does anyone know why my newly installed klipperscreen is flipping to the print list menu?

[tasslehawf]

Basic Information:

Printer Model: Voron trident
MCU / Printerboard: BTT Manta E3EZ w/ CB1
Display: BTT tft35 spi
klippy.logklippy-7.log (5.3 MB)

Describe your issue:

Even time I startup or go manually back to the main status screen, klipperscreen flips back to the printing list screen automatically. It doesn’t do it from any other screen. I didn’t see an option in the UI to change it or in the documentation.

[Schuessel]

Hi,
i think that is the same Problem that triggers the Display-Points like in this case:

Klipper auto starts printing after a print finish

Hello, Im new to Klipper and I’ve installed a Manta M5P with CB1 into my Anycubic mega pro. after doing my research before installing the board I set Klipper up and learning it. After installing it I didn’t get any errors just had to flip 2 motors. so I go lucky. But what I’m having a problem with is. After a print finish the printer starts up again and starts printing again. I can’t find anything on this. Im using the default end_print code. but added a few lines. What am I over looking or a…

since it is the same Area that must have been triggered.

I’m not sure but i think i’ve seen that after a while in standby on my Printer too.
Looks more and more like there is a Problem with the Manta-Boards and the BTT-tft35.

[tasslehawf]

I decided I hated the TFT35 and replace it with an HDMI5 and I much happier even with the wires sticking out the side. The performance is on par with a raspberry pi display.