Ender 3 max neo offsetting from the center

General Discussion
1

Basic Information:

Printer Model: Creality Ender 3 Max Neo
MCU / Printerboard: Creality 4.2.2
Host / SBC: Creality sonic pad
klippy.log
klippy(2).log (29.2 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Issue #1: The nozzle won’t go to the center of the plate when I enter the coordinates that should be the center (X: 150 / Y: 150). When I do this, the nozzle go to a slightly different coordinates, a couples of cm down and to the right.

Issue #2: I suspect that this has something to do with issue #1, and it’s that the probe calibration isn’t centered in the plate, the first probe point is outside of the plate and of course the probe calibration sequence fails.

I will also upload the printer.cfg
printer.cfg (7.1 KB)

And now I’ll add some images.

IMG_9996
IMG_99961920×1440 192 KB

…

2

It’s hard to say why that happens. We do not know what Creality did to Klipper.

2 Likes
3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.