Basic Information: Printer Model: Ender 6 MCU / Printerboard: SKR Mini E3 V3 & OctoKlipper on RPi4B klippy.log Describe your issue: As the title says I’m trying to configure my Ender 6 to work with Klipper. I’ve followed multiple instructional guides online; How to install Klipper on the SKR M…

I do not see any immediate benefits of one over the other. This largely depends on your requirements If you just want a webinterface to click on “print” and jog around a bit then both will fully do If you have special workflows or need special plug-ins then stick to Octoprint If you feel comforta…

That’s written in your klippy.log [mcu] serial = /dev/serial/by-id/“your-mcu-id” That “your-mcu-id” doesn’t make sense! You could read the docs of Klipper or Sineos “Knowledge Base” before asking! [image] How-To Trouble-Shoot Knowledge Base How-To Troubles…

Thanks for the link, I will begin to familiarize myself. Sorry for old log, I have an updated one here klippy.log (4.4 KB)

You have an error in your printer.cfg: [printer] kinematics = corexy max_velocity = 500 max_accel = 2000 max_z_velocity = 10 max_z_accel = 100u This should be: max_z_accel = 100 and:

[image] I seem to have solved the configuration file issues but now I am stuck with this screen. Also, is it possible to force update of klippy.log? [image] Edit: New log klippy.log (25.6 KB)

OctoKlipper? That’s quite old fashion.

I like all the open source plugins and ability to monitor from afar. But I’m open to suggestions, especially if this might likely be an OctoKlipper issue

[image] hcet14: That’s quite old fashion. Please don’t say that! Some people like to work with it. And: On OctoPrint, Klipper was developed. [image] Klipper Architecture / Ecosystem Knowledge Base Klipper Architecture / Ecosystem Calling Klipper a 3D …

[image] EddyMI3D: Please don’t say that! Ok, I’ll never say it again :face_with_open_eyes_and_hand_over_mouth: All I wanted to state was: That’s just my opinion!

“I prefer X before Y” Sounds nicer than: “Y is bad” doesn’t it?

[image] EddyMI3D: “I prefer X before Y” Sounds nicer than: “Y is bad” doesn’t it? Are you addressing me? If yes, I don’t get it. But back to the topic [quote=“EddyMI3D, post:8, topic:12041”] And: On OctoPrint, Klipper was developed. Do you remember [image] New submiss…

Ender 6 w/ OctoKlipper

General Discussion

EddyMI3D December 3, 2023, 7:42pm 8

Please don’t say that!

Some people like to work with it.
And: On OctoPrint, Klipper was developed.

Topic		Replies	Views
Printer main board not flashing klipper General Discussion	13	346	October 15, 2024
Changed printerboard klippy not connected General Discussion	5	477	December 23, 2024
Despite following the guide on the Klipper docs perfectly, it is unable to connect to my printer General Discussion	18	2518	December 3, 2023
Need help creating a config for a frankensteined ender3 General Discussion	10	2804	September 15, 2023
Ender 3 V2 not connecting General Discussion	30	4339	September 15, 2023

Ender 6 w/ OctoKlipper

Related topics