Basic Information: Printer Model: VORON 2.4 MCU / Printerboard: klippy.log Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Knowledge Base” Category first. Most relevant i…

[image] gergg: Fill out above information and in all cases attach your klippy.log file No log, no way to help.

Edited. Original post was wrong

so it’s not connected to the board? just a question, how can I connect it? I didn’t really understand what is described in the instructions and to which connector I can connect it. will the PROBE connector work? and how to specify its pins?

Never mind, I read your log wrong. I’m on mobile so I’m going to let someone else take this. I can’t effectively evaluate the log.

[pic] can I use this? BTT octopus V1 board

[image] jakep_82: Never mind, I read your log wrong. You can’t rename an existing gcode to the same name. The rename existing should rename it to something else if I attach a klicky-macros file, can you help me?

Okay, thanks for the help. I just downloaded the files from github, downloaded them practically without changing anything, and they also give an error and I’m confused what could have happened… I did everything according to the instructions in YouTube

It seems you somehow deleted your [probe] section and as such there is no command to rename

and in which of the files should it be located and where should I find it now?)

Existing command 'PROBE_CALIBRATE' not found in gcode_macro rename

General Discussion

jakep_82 September 27, 2023, 2:00pm 2

No log, no way to help.

Topic		Replies	Views
Klipper "Internal error on command:"PROBE_CALIBRATE"" General Discussion	4	2199	October 2, 2025
Error: Existing command 'BOB' not found in gcode_macro rename - What am I missing? General Discussion	3	245	September 21, 2024
Unknown command:"PROBE_CALIBRATE" General Discussion	2	174	September 2, 2024
Bltouch and printer.cfg General Discussion	2	254	June 17, 2024
Unknown pin chip name 'probe' after updating Klipper General Discussion	9	4743	April 3, 2024

Existing command 'PROBE_CALIBRATE' not found in gcode_macro rename

Related topics