Firmware restart after cancel print

General Discussion
1

Basic Information:

Printer Model: MakerTech Proforge 3.5 DSH (Dual Switching Head)
MCU / Printerboard: SKR 2
klippy.log

Everytime I cancel a print, I have to restart the firmware.
Klipper will not reset. The only option is to resume printing even though I cancelled the print job.

Any help is much appreciated!

Thanks,
David

2

The klippy.log is much appreciated too.

3

Forum won’t accept the upload.
File is over 8mb

Suggestions?

4

Zip the file. It should end up under 8mb

5

Well, I should have thought of that. It’s going to be a long day…

Here you go.
klippy.log.zip (861.2 KB)