Hello
I installed the klipper firmware on a GEEETech i3 printer. Then I made a mainsailOS on an sd card with an imager. Mainsail sees the printer, but when I warm up the extruder or the bed, mainsail and the firmware restart.
It worked with Merlin firmware and octoprint.
Hello @balu999 !
Obviously you did not read this before deleting:
[DELETE_ME_AFTER_READING]
This category is for posting working configs only. It is not intended for support or questions.
[/DELETE_ME_AFTER_READING]
Please try again in General Discussion.
Do not delete the template.
Provide all information that is asked for.
Do not Copy&Paste. Please upload files here
