Issues isntalling klipper ENDER3V2NEO GD32F303

General Discussion
1

Basic Information:

Printer Model: ENDER 3 V2 NEO
MCU / Printerboard: v4.2.2 clone GD32F303
klippy.log

Describe your issue:

hello

I’ve been trying to install Klipper firmware on my printer with the v4.2.2 GD32F303 board for a couple of days, and it seems impossible. I’ve seen some people with the same problem, but no definitive solution. The fact is that mainsail does not recognize the console. I don’t know if when I put the firmware it has really installed it, since the screen stays with the crality logo, but the .bin of the sd doesn’t change its name either, so I don’t know if it has been installed. It doesn’t change the name either. name when I put a correct marlin firmware.

thanks

2

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.