Basic Information: Printer Model: Dremel 3D45 MCU / Printerboard:Unknown/partially known Host / SBC klippy.log Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Knowledge…

if you need help with the Dremel specific part, I might be able to help. However I do not have access to a 3D45, maybe you can post a picture of the motherboard here.

Alright. I have the version 0.8 or the board. The PDF above is v 1.1. I’ll attach a photo of it. [3D45_board] Edit: how do you remove the metal shields? Just prying?

This board looks similar, but not identical to the one in the 3D40. Quite frankly it has been a long time since I opened the shield. I cannot remember, whether there were a few solder spots or whether you could just remove the shields without any additional effort. But solder spots you should be ab…

Alright so here’s the question then. As a beginner to electronics, is it more worth it to scrap this mobo and purchase another than can hook into the existing motors and sensors? If so, and recommendations that will work? Or what would the requirements for a board that could replace this one? Tha…

quite frankly that is a touch question. The Dremel uses a custom connector to the print head, so you would need to create a custom solution how to adopt to this, e.g. build a small PCB. This is probably of similar complexity than reflashing the motherboard and creating the few wires to bring out the…

sorry, meant to write tough, not touch

I am in the New England area in USA. I will look more closely into the differences between the boards. Since this has to do with the usb, will the usb camera that is install be of any use? The plug J1302 is the camera plug (5 pins though).

Getting started on dremel 3D45

General Discussion

Sineos August 9, 2024, 7:10am 2

See Printer.cfg for Dremel 3D40 - #3 by STS and Installing Klipper with KIAUH

Topic		Replies	Views
Printer.cfg for Dremel 3D40 Configs	2	629	January 21, 2024
Dremel 3d45 burnt stm32 General Discussion	0	57	January 5, 2025
First klipper config... board not listed General Discussion	10	2381	November 2, 2023
Support for new Creality boards 4.2.2 with GD32F303 General Discussion	56	41121	November 8, 2023
SV01 Pro Stock Board General Discussion	0	362	December 14, 2022

Getting started on dremel 3D45

Related topics